REMKO RKV 13 C - Manual (Page 10)

10
à If the timer function is activated, the unit checks the
room temperature one hour before the programmed
start-up time. Based on the start-up time, the unit
can start between 0 and 40 minutes ahead of time
depending on the temperature difference between
the room temperature and the selected temperature.
Timer off button (18)
To program the timer shut-down time, press the button
(18) . The corresponding display symbol and the time
begin to blink on the display. This function can also be
selected when the remote control is switched off.
Use the buttons (8) and (9) to set the time at which
the unit should switch off. Press the button (18) to
switch from hours to minutes and, to confirm the setting,
press the button (18) again.
Combined timer program
The timer on/off program can be combined with the
Timer daily function.
1. To do this, activate the programs as already de-
scribed.
The corresponding symbols appear on the display.
Timer on button (14)
A timed program can be set and activated for unit op-
eration with the (14) button. The “Timer in Function”
mode is indicated when the yellow light on the reception
display of the ceiling cassette lights up.
Timer daily button (15)
The saved program to switch the unit on or off is re-
peated on a daily basis with the Timer daily button.
1. Press the button (15) while a timer on/off program
is activated.
The corresponding symbol appears on the display.
Timer delete button (16)
The timer settings are deleted as follows:
1. To delete a start-up program, press the button (14)
and then the button (16) .
The corresponding symbol disappears from the dis-
play.
2. To delete a shut-down program, press first he button
(18) and then the button (16) .
The corresponding symbol disappears from the dis-
play.
3. Remember: if the unit is already switched on, it is
only possible to program another start-up time.
The current settings of the unit are transferred for
this start-up time.
M
4. When the unit is switched off, set the time for the
unit to switch on using the temperature selection but-
tons (8) and (9) .
5. First select the hours and once you have confirmed
the entry by pressing the button (14) , enter the
minutes also with the button (8) or (9) .
To complete entry of the timer program, press the
button (14) again.
6. Select the operating mode of the unit with the button
(6) .
The operating mode symbols blink.
7. Confirm the operating mode you want by pressing
the button (14) .
The symbol for this operating mode no longer blinks.
8. To select the temperature you want, confirm either
by pressing the buttons (8) or (9) and confirm
your selection with the button (14) .
The temperature display no longer blinks after confir-
mation.
9. Select the fan speed with the button (10) and con-
firm your entry with the button (14) .
The symbol no longer blinks.
10. Select the last position of the air direction plate fins
with the button (13) and confirm your selection
with the button (14) .
The symbols of the air direction plate fins no longer
blink after confirmation.
11. Press the button (16) if you want to delete the pre-
viously saved settings or press the button (14) and
then the button (16) if you want to delete all timer
settings.
2. Press the button (15) again to deactivate the
Timer daily function.
The corresponding symbol disappears from the dis-
play.
Proceed as follows to set the timer program:
1. Press the (14) button.
Also possible when the remote control is switched
off.
2. Remember: the corresponding symbol and the time
specification begin to blink on the display. If a button
is not pressed within ten seconds, the timer function
is automatically deactivated.