REMKO RKL 220 - Manual (Page 9)

9
Water Tank
The integrated water tank must be emptied from time to
time.
When the water tank is full, an alarm
goes on and the "FULL TANK" display
blinks.
The unit switches off automatically. FULL TANK
1. Wait a few minutes before removing
the water tank.
In our experience, a little bit of water
always drips out of the unit.
2. Carefully remove the full water tank.
3. The contents of the tank can be
poured down a drain.
4. We recommend cleaning the tank
with a clean cloth.
Unit Shut Down
8. Reinsert the water tank properly.
9. Clean the dust filter and the unit
housing.
10. Follow the service instructions.
11. Store the unit in an upright position
away from dust and direct sun light.
12. Protect the unit from dust with a
plastic cover.
1. Switch the unit off with the "On / Off"
button.
2. Unplug the power cable after press-
ing the "On / Off" button.
This will prevent the device’s elec-
tronic system from being damaged.
1. Let the device run for approximately
2 hours in ventilation mode (FAN) to
dry the surface of the evaporator
plate fins.
This will prevent unpleasant odors
when the device is put back into op-
eration.
2. Switch the unit off with the "On / Off"
button.
3. Remove the plug from the plug
socket and secure the power cable
on the holder.
4. Make sure that the cable is not bent
and that there are no kinks.
5. Empty the water tank.
6. Remove the remaining water via the
tube to the left in the opening for the
water tank.
7. Make sure to replace the sealing cap
on the tube.
If the sealing cap is not replaced,
water may leak out.
Prior to longer idle periods
◊ Remove the dust filter.
◊ If the dust filter is only slightly dirty,
clean off the dust, for example, with
a vacuum cleaner.
◊ If the dust filter is very dirty it is to be
washed with a lukewarm soap solu-
tion (max. 40° C) and then to be
rinsed with clear water.
◊
Make sure that the dust filter is com-
pletely dry and undamaged before
you reinstall it.
In case of extreme dirt the dust filter
is to be replaced.
Cleaning the Dust Filter
The device is equipped with a dust filter. It can be opened
on the left side and removed.
Cleaning the plastic housing:
For cleaning, please use only a clean, soft, slightly
damp cloth to carefully wipe off the housing. Please ad-
here to the following instructions:
◊ Never use chemical cleaning agents or polish to
clean the device.
These can corrode the surface.
◊ Make sure that moisture does not enter the device.
Water and other liquids may never be sprayed di-
rectly into the unit.
This can damage the electrical system.
Maintenance and Service
Never use the unit without the dust filter installed!
Without a dust filter, the evaporator’s plate fins be-
come dirty and the performance of the unit suffers.
The power cable must be unplugged before any
work is done on the unit!