REMKO RKL 220 - Manual (Page 6)

6
Operation
The unit may only be put into operation once it has been
installed following all instructions contained in the “Safety
Hints” and “Installation Instructions” sections.
1 "On / Off" button
2 "MODE" button (operating mode and fan setting)
There are 5 options available. Display 11 shows the
selected operating mode.
The sequence is: AUTO žHIžMEDžLOžFAN
AUTO Cooling mode, automatic fan rotation inde-
pendent of room temperature.
HI Cooling mode, highest fan setting.
MED Cooling mode, medium fan setting.
LO Cooling mode, lowest fan setting.
FAN Ventilate only, no cooling.
3 Display
Normally, the target temperature is displayed here. If
the thermo control button or the TIMER button is
pressed, the display switches for 5 seconds to the
corresponding setting.
4 "THERMO CONTROL" button (temperature selection)
After the unit has been connected to the power supply
and manually switched on, the target temperature is
automatically set to 25°C. This can be changed using
the arrow buttons 4 in 1°C increments between 20
and 30°C:
Left arrow button = Higher target temperature
Right arrow button = Lower target temperature
This is shown in display 3.
5 "TIMER" button (timer clock)
The timer can be preset for a maximum of 24 hours.
The amount of time is shown on display 3. The timer
has two functions:
1. Unit switches on automatically
When the unit is off, using the "SET" button, the user
can enter the number of hours after which the unit is
to be switched on. Each time the button is pressed,
the number of hours is increased by 1. If this function
is activated, "TIMING ON" 9 is lit up.
After the timer has been activated, the operating
mode and target temperature can be set as de-
scribed above.
2. Unit switches off automatically
When the device is on, using the "SET" button, the
user can enter the number of hours after which the
device is to be switched off. Each time the button is
pressed, the number of hours is increased by 1. If
this function is activated, "TIMING OFF" 10 is lit up.
23
Control panel
12
1
2
4
3
5
10 9
6
7
8
11
Information about the timer:
◊ If the "On / Off" button is pressed when the timer is
set to switch the device off, this setting is cleared
and the unit switches off.
◊ If the "SET" button is pressed while the timer is acti-
vated, the remaining time is shown on the display.
Each time the "SET" button is pressed, the remain-
ing time is increased by one hour.
6 "AUTO SWING" button
Pressing this button activates the automatic motion
of the vertical plate fins on the air outlet grill. Pressing
this button again stops this motion.
The "AUTO SWING" function can be deactivated by
repeatedly pressing this button in quick sequence to
adjust the direction of the vertical air outlet.
Never adjust the vertical plate fins manually!
The unit is only guaranteed to operate at room
temperatures of 20 - 35 °C.
To disable the timer or change the setting, press
the "RESET" button.