Remko pwl, Customer service and warranty, Intended use – REMKO PWL 101 HK User Manual
Page 20: Environmental protection and recycling
20
REMKO PWL
NOTE
Operation for any other pur-
pose than that described in
these operating instructions
is not permitted. Failure to
observe this requirement will
result in all liability being
disclaimed and the warranty
rendered invalid.
Customer service and
warranty
A precondition for any warran-
ty claims is that the dealer or his
customer has completed and
returned the enclosed “Warranty
document“
to REMKO GmbH &
Co. KG at the time of sale and
commissioning.
The units were repeatedly tested
for perfect functioning at the
factory.
If problems should occur which
cannot be remedied by trouble-
shooting by the operator, your
specialised dealer or contract part-
ner should be contacted.
Intended use
Disposal of packaging
When disposing of the packaging
material, please think of the envi-
ronment.
Our units are carefully packed for
transport and delivered in sturdy
cardboard packaging on a wooden
pallet, if necessary.
The packaging materials are
environmentally-friendly and can
be recycled.
By reusing packaging materials,
you make a valuable contribution
towards waste reduction and the
conservation of raw materials.
Only dispose of packaging materi-
al at the facilities provided.
Disposal of old unit
The production of our units is sub-
ject to constant quality controls.
Only high-quality materials are
used, the majority of which are
recyclable.
Make your contribution towards
environmental protection by dispo-
sing of your old unit in an environ-
mentally-friendly manner.
Only dispose of your old unit at
an authorised recycling facility or
similar.
NOTE
Adjustments and maintenance
must only be carried out by
authorised specialists.
Environmental
protection and
recycling
ATTENTION
Copyright
Any copying of this docu-
ment in whole or part or use
for purposes other than the
intended is strictly forbidden
without the prior written
permission of
REMKO GmbH & Co.
KG
.
Due to their design and equip-
ment, the units are intended solely
for heating and cooling purposes
in industrial or commercial use.
The units must only be operated
by suitably trained personnel.
The manufacturer disclaims all
liability for any damage attributed
to failure to observe relevant in-
structions, statutory requirements
applicable at the place of use or
unauthorised changes to the unit.