PSE Archery Crossbow 2013 - Manual (Page 4)

CROSSBOW OWNER’S GUIDE
®
7
crossbow owner’s guide
®
6
Fig. 2 Fig. 1
Note: The quiver can be
installed in either direction.
Fig. 3 Fig. 4
Fig. 5
crossbow owner’s guide
®
copperHead ™ and reaper ™ modeLs enigma ™ and toxic ™ modeLs
mounting tHe Quiver
Parts to install quiver:
A. Quiver
B. Quiver mount bracket
Locate the two pre-installed screws on the side of the stock. Fig. 1
Remove these screws and install the bracket with the screws as shown in Fig.2
Slide the quiver into the quiver mount by sliding it into the end of the bracket. Fig.3
Fig. 1
Fig. 3
A
B
Fig. 2
Note: The quiver can be
installed in either direction.
A
B
C
D E
F
G
mounting tHe Quiver
Parts to install quiver:
A. Quiver
B. Quiver mount bracket
C. Dovetail bracket
D. Backing plate
(Reaper and Copperhead only)
E. Round head screws
F. Flathead screws
G. Allen key
Place backing plate (D) and QD bracket over two holes on underside of the prod
(Fig. 1) and secure with the two flat head screws (which go through both the QD
bracket and the backing plate) (F) with the Allen key provided. (G) Make sure the
backing plate is under the QD bracket
(All models) Secure the dovetail bracket bracket (C) to the quiver (A) using the
round head screws (E) with a Phillips screwdriver. (Fig. 2)
Mount the quiver mount bracket (B) to the underside of the prod assembly using
flathead screws (F). Slide the the quiver into the mounting bracket (Fig. 4) and
secure using the locking lever (Fig. 5)