Crossbow owner’s guide – PSE Archery Crossbow 2013 User Manual

Page 3

CROSSBOW OWNER’S GUIDE

compound crossbow assembLy

Before shooting your crossbow, some basic assembly is required.

Mount prod to stock assembly. Clip the cable slide on top of the

cables with one cable in each slot.(Fig.1, 1b) Place slide in the

center of the prod. Slide cables and slide into cable slot of stock

assembly with the string riding on top of the rail. Insert the prod

into stock assembly as shown in (Fig. 2, 2b). Install the stirrup and

secure with the prod attachment screw (Fig. 3, 3b), Tighten screw

with the Allen key provided.

*On Copperhead and Reaper Models: Place the stirrup into the

front mounting holes of the prod assembly (Fig. 4) and tighten the

set screws.

(enlarged)

Fig. 1

Fig. 2

Fig. 3

(A) Prod assembly*

(B) Cable slide (one)

Left-Steel cables

Right- Synthetic Cables

(D) Fore-End (Stock assembly)

(E) Cocking strap

(F) Scope*

(G) Bolts (Arrows)

(H) Allen wrenches

(I) Set Screws*

(J) Sling*

(K) Quiver*

(L) Quiver mount*

(M) PSE Wax Stick*

(N) Safety glasses

Fig. 1b

Fig. 2b

Fig. 3b

Fig. 4*

*May vary from picture shown or may not be available on all models

Note: figure 4 at left is for

copperhead and Reaper

models only.