Posiflex LM-2212X - Manual (Page 11)

Activating Power Output to LM-2x12X via POS System BIOS
In general, Posiflex terminals will disable the VGA controller in BIOS due to
safety concerns. Therefore, to ensure LM-2212X/2312X/2412X is able to
extract power from the Posiflex XP/KS series terminals, it is necessary to
manually enable the VGA output of the terminals in BIOS settings before the
monitor starts up. However, if the monitor you are using is not manufactured
by Posiflex, it is strongly suggested to deactivate the VGA port of your
terminal in preventing your device from being damaged.
Please go through the below instructions to activate the power output for LM-
2212X/2312X/2412X. DO NOT plug the VGA cable into VGA connectors
while the terminal is still running.
1. Make sure that LM-2212X/2312X/2412X is well connected to the
Posiflex XP/KS-series terminals using the VGA cable.
2. Press the power button of the POS to power on the POS. During the boot
process, hit F2 key to access BOIS setting.
3. Use arrow keys to check the setting of CRT - 12V output option under
Intel tab. If it is set to be disabled, hit Enter key to enable the VGA port.
4. Switch to Exit tab and select Exit Saving Changes option. Choose Yes in
Setup Confirmation message box to save your configurations.
5. After rebooting your POS, make sure LM-2212X/2312X/2412X is
correctly detected.
11