Posiflex MS-5145 - Manual (Page 7)

7
Stand-Alone Keyboard
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector into the jack on the Eclipse.
There will be a ’click’ when the
connection is made.
3. Connect the L-shaped plug of the
power supply into the power jack on
the PowerLink cable.
4. Make sure the AC input requirements
of the power supply match the AC
outlet. Connect the power supply into
an AC outlet. The outlet should be
near the equipment and easily
accessible.
5. Connect the PowerLink cable to the
keyboard port on the host system.
6. Turn on the host system.
Figure 8. Stand-Alone Keyboard
Installation Note
Powering the MS5145-47 directly from the computer can
sometimes cause interference with the operation of the
scanner or the computer. Not all computers supply the
same current through the keyboard port, explaining why
a scanner may work on one computer and not another.
Contact a customer service representative if an external
power supply is required.
See caution on page 5.