Posiflex KB-4000 - Manual (Page 4)

Part 4
them as indicated in the picture at above left.
CABLE CONNECTION
Connection To Host
Please refer to the pictures above with numbered parts illustration listed
below them. The USB cable could be absent from KB-4000 / KP-100 / KP-110
if the product is purchased without the smart card reader. On the contrary, KP-
100U/ KP-110U is equipped with only USB cable with no PS/2 KB cable. If it
is SD-100 with only the iButton receptor there will only be the PS/2 cable and
RS232 cable. If SD-100 or SD-110 is of PS2 interface there will only be the
PS2 cable. Connect the USB connector of KB-4000, KP-110, KP-110U or SD-
110 to a USB hub or the USB port in a PC or a Posiflex POS system. Connect
the USB connector of KP-100, KP-100U or SD-100 to one of the USB ports of
Jiva TP/LT series in connector area. Connect the PS/2 KB connector of KB-
4000, KP-110 or SD-110 to the PS/2 KB jack in a PC or a Posiflex POS
system. Connect the PS/2 KB connector of KP-100 or SD-100 to the PS/2 KB
jack in Jiva TP/LT. When the SD-100 is installed with iButton receptor, there
will be one additional 9 pin female D connector and a pair of male/female PS/2
keyboard connectors from the upgrade kit. Connect the D connector to the
COM port for iButton setup (and data connection). Connect the male PS/2
keyboard connector to the keyboard port in Jiva TP/LT series for data
connection if KB interface is selected for data input of iButton key. Route the
cable connection for KP-100, KP-100U or SD-100 to Jiva TP/LT series
through the side of the cable cover on Jiva series. Break the obstructing side
wall of the cable cover in the cable entrance to the connector area according to
the needs. Route the cable connection for KP-110, KP-110U or SD-110
SD-100 / SD-110
1
2
4
3
7 or 8
KB-4000
1 2 3 4
7 5 6 8
1. MSR slot
2. MSR mark
3. Smart card reader slot
4. Smart card reader mark 5. Numerical keypad
6. Programmable keys
7. USB cable
8. PS/2 KB cable
1
2
3
4
7
5
6
8
KP-100 / KP-100U
KP-110 / KP-110U