Posiflex KB-4000 - Manual (Page 3)

Part 3
INSTALLATION
UNPACKING CONTENTS
Items packed in for KB-4000
KP-100/ KP-
100U/ KP-110
/ KP-110U
SD-100
/SD-110
The multifunction security device itself Yes Yes Yes
Screws to hold the upgrade kit to Jiva
TP/LT series or TM-4115 series
No Yes Yes
24 pcs transparent key caps for single key Yes Yes No
1 pc of key clip Yes Yes No
Legend sheets Yes Yes No
This manual Yes Yes Yes
Utility drivers stored in form of CD ROM Yes No No
iButton key (only when iButton receptor
installed)
No No 2 pcs
Note: Utility drivers for KP-100 / KP-110 series and SD-100 / SD-110 can be
found in the Posiflex Product Information CD ROM packed together with
the Jiva series Posiflex touch terminal system or TM-4115 monitor that
these upgrade kits are to be applied to. Or please visit our web site for
latest updates: http: www.posiflex.com or http: www.posiflex.com.tw
MECHANICAL FIXATION
For KB-4000 the stand alone security device, there is little concern
about the mechanical fixation as long as the security device (keyboard) is
placed in a horizontal flat surface not subject to extreme environmental
conditions. For SD-100 ordered with the Jiva TP / LT series or SD-110
ordered with TM-4115 series, it is installed on the system or monitor on
delivery. For separately ordered SD-100 / SD-110 or KP-100/ KP-100U / KP-
110/ KP-110U, it is delivered separately from the system or monitor and needs
to be fixed onto the system or monitor
per following instructions before use.
You may find two screw holes on
back of the right side of the main unit of
Jiva TP/LT series
or TM-4115 series
as in the right
picture. Just align the upgrade unit on the right edge of
the main unit after removing these 2 screws then replace
them with the attached 2 screws with washers and fasten
Back of Jiva
TP/LT Series
Upgrade Unit
Screw Holes
Cable Entry