Posiflex PD-2609UE - Manual (Page 8)

Adjusting the DIP Switch Settings for PD-2609UE
DIP Switch of PD-2609U, which is comprised of six electrical switches
located at the rear of the customer display, allows you to save your
preferences for USB class and emulation commands. The below figure
gives the list of four available combination of DIP switch settings for
your reference.
USB Class
DIP switch #1 and #2 are mainly responsible for deciding the interface
via which your POS terminal would interact with the customer display.
The below table describes four different combinations of DIP switch
settings supported by PD-2609UE for your reference.
Switch Position
USB Class
1 2
ON ON USB Vendor Class
ON OFF USB HID Class
OFF ON Reserved
OFF OFF Virtual COM Port
Emulation Mode
A good range of commands emulation is also provided in PD-2609UE.
By setting up DIP switches from #3 to #6 in order according to the
below table, you may specify the type of command sets which your
pole display will emulate.
Switch Position
Emulation Mode
3 4 5 6
ON ON ON OFF UTC
ON ON OFF OFF Aedex
ON OFF ON OFF Noritake (Default)
ON OFF OFF OFF Epson
OFF ON ON OFF Futaba
OFF ON OFF OFF ADM
8