Posiflex JIVA XT-3015 - Manual (Page 16)

Part 16
Indicator Status
System
Status
External
Power
UPS Battery Powering Up
Off Off Off Not present Not possible
Off Off Off Present Not allowed
Orange Off On No influence Allowed
Blue On On No influence Not required
Blue/flash On Off Activated Not required
Orange/rapid
flash
On Off
Running at
low capacity
Not required
Hardware Power Switch
The power switch located in the left side of the main unit is a push on/off
switch. This switch controls the power on/off of the system.
The power switch turns the system on when pushed during AC power
available , and will turn the system off when pushed again while the system is
powered on. However, if the system hangs for any reason, simply pushing the
power switch for at least 10 seconds can power off the terminal.
If above action fails to shut down the terminal, please disconnect the UPS
battery if installed and the AC power supply.
Note: There must always be at least 3 seconds waiting before switching on
again once the system is powered off successfully.
Software Support Features
The XT series provides a software power off command for application
program maneuvers. The XT also provides a specific means for the software to
detect if the system is working on external or UPS battery power. Due to this
feature, compatible software applications have the ability to change operating
conditions when running on standard/backup power. The software programmer
may take reference from the XT technical manual to apply such features.
Automatic Power on Control
The XT system may also turn on according to some preset conditions such as
Alarm Clock Wake Up or LAN Wake Up.
To utilize Alarm Clock Wake Up function, the user should enter the BIOS
setup by pressing “F2” key at system boot up, choose in “Power” and enable
the “Resume on Time” for Alarm Clock Wake Up. Then enter the assigned