Posiflex JIVA XT-3015 - Manual (Page 14)

Part 14
UPS Battery Installation Inside Gen 8/8E BASE:
Inside Gen 8/8E base, UPS battery can be installed below:
Step A: Slide the UPS battery pack inside
the cavity then tighten the indicated 2
screws included in the package at delivery.
Step B: Route the UPS battery cable to the indicated passage of base stand
then connect at the power port end
of the mother board.
Step C: For un-installation, go back to UPS battery
installation procedure in its reverse way.
CONNECTING CASH DRAWER (OPTIONAL)
The CR connector in I/O area of a XT series system can be used for
controlling most of Posiflex cash drawers available on the market.
This cable has an 8-pin plug at one end and a 6-pin plug at the other.
The 6-pin plug should be inserted into the connector of the POS
system terminal. The 8-pin plug should be inserted in the connector of
cash drawer.
OPERATING SYSTEM INSTALLATION
OS installation into a system without preloaded OS is highly discouraged.
Posiflex Technology, Inc. shall not be responsible for any technical support to
questions on this aspect.
APPLICATION ENVIRONMENT
It is very important that you check the following operational guidelines:
Ventilation
This terminal must NOT be operated in an environment with restricted