OWON AG-S series - Manual (Page 39)

5.Front Panel Operation
To Set the System
Language Setting
Press Utility and choose System, press F1 to switch display languages.
Power On Setting
(1)
Press Utility and choose System, press F2 to select Power On.
(2)
Press F2 to switch between Default/Last. Default means that all the settings
return to default when powered. Last means that all the settings return to the last
one when powered.
To Return to Default Setting
Press Utility and choose System, press F3 to select Set to Default. All the settings
will be set to default. The default settings of the system are as follows:
Output Default
Function Sine Wave
Frequency 1kHz
Amplitude/Offset 1 Vpp / 0 Vdc
Terminals High Z
Modulation Default
Carrier 1kHz Sine Wave
Modulating 100Hz Sine Wave
AM Depth 100％
FM Deviation 100Hz
PM Phase Deviation 0°
FSK Hop Frequency 100Hz
FSK Frequency 100Hz
PWM Width Deviation / Duty
Deviation
0ns/0%
Source Internal
Sweep Default
Start/Stop Frequency 100Hz/1kHz
Time 1 sec
Mode Linear
34