OWON AG (-F) Series - Manual (Page 41)

5.Front Panel Operation
36
Note:
For either of CH1 Output and CH2 Output on the Front panel, the waveform generator
has a fixed 50Ω Series Impendence. No matter what Value the set parameter is, if the real
load is different from the set one, the displayed voltage will not equal the real voltage.
To Set the Phase Deviation
You can set the phase deviation of the two channels.
(1)
Press Utility and choose Output Setup, press F3 to select PhaseDev.
(2)
Press F3 to switch between On/Off.
(3)
If On is selected, you can set the value of phase deviation. Turn the knob to change
the value, press
/ direction key to move the cursor left and right; or press the
number keys to input the desired value in degree, press F4 to select the unit. The
phase deviation range is 0 - 360°.
To Set the System
Language Setting
Press Utility and choose System, press F1 to switch display languages.
Power On Setting
(1)
Press Utility and choose System, press F2 to select Power On.
(2)
Press F2 to switch between Default/Last. Default means that all the settings
return to default when powered. Last means that all the settings return to the last
one when powered.
To Return to Default Setting
Press Utility and choose System, press F3 to select Set to Default, press F1 to
confirm. All the settings will be set to default. The default settings of the system are as
follows:
Output Default
Function Sine Wave
Frequency 1 kHz
Amplitude/Offset 1 V
p-p
/ 0 Vdc
Waveforms Default
Frequency 1 kHz
Amplitude
1
V
p-p
Offset
0 Vdc
Duty Cycle of Square 50%
Symmetry of Ramp 50%