OWON AG (-F) Series - Manual (Page 20)

5.Front Panel Operation
15
To Output Ramp Signals
Press button to call the user interface of Ramp signal, the Ramp waveform
parameters can be set by operating the Ramp setting menu on the right.
The parameters of Ramp waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Symmetry. You can operate the menu by using the menu selection
buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to To
Output Sine Signals on page 12.
Channel
Setting menu
of Ramp signal
Amplitude
Load
Offset
Current signal
Frequency
Parameter 1
Symmetry
Parameter 2 Parameter 3
Figure 5-6: The User Interface of Ramp Signal
Term Explanation
Symmetry:
The percentage that the Rising Period takes up the whole Period.
To Set the Symmetry
(1)
Press F4 button, the "Symmetry" menu item is highlighted, the current value of
the symmetry is displayed in Parameter 1.
(2)
Turn the knob to change the value directly;
or press the number keys to input the desired value, press F4 to choose "%".