OWON AG (-F) Series - Manual (Page 22)

5.Front Panel Operation
17
Term Explanation
Pulse Width:
There are two kinds of Pulse Width—positive and negative.
Positive Pulse Width is the time span between thresholds of 50% of the rising edge
amplitude to the next 50% of the falling edge amplitude.
Negative Pulse Width is the time span between thresholds of 50% of the falling edge
amplitude to the next 50% of the rising edge amplitude.
Pulse Width is determined by Period and Duty Cycle;
the formula is: Pulse Width = Period * Duty Cycle.
To Set the Pulse Width / Duty Cycle
(1)
Press F4 button, the chosen menu item is highlighted, the focused parameter is
displayed in Parameter 1. Press F4 to switch between Pulse Width/Duty.
(2)
Turn the knob to change the value directly;
or press the number keys to input the desired value and choose the unit.
Figure 5-9: Set the Pulse Width of Pulse signal
To Output Noise Signals
The noise signal which the generator output is white noise. Press button to call the
user interface of Noise signal, the Noise waveform parameters can be set by operating
the Noise setting menu on the right.
The parameters of Noise waveform are: Amplitude/High Level, Offset/Low Level. You can
operate the menu by using the menu selection buttons on the right.
To set the Amplitude/High Level, Offset/Low Level, please refer to To Output Sine Signals
on page 12.