Osburn OB01111 User Manual
Page 33
33
BRICK LAYOUT
Figure 3.3
SECONDARY AIR TUBE REPLACEMENT
(See Figure 3.4)
1.
Remove cotter pin at LH end of tube.
2.
Slide tube to right and lower tube end below LH plenum.
3.
Slide tube to left to remove.
4.
Reassemble in reverse order using a new cotter pin. The cotter pin is a
hammerlock style and locks into place by hitting the head sharply with a hammer.
5.
Note that any tube can be replaced without disturbing the baffle.
Figure 3.4 – Secondary Air Tube replacement
This manual is related to the following products: