Osburn OB01111 User Manual
Page 32
32
BAFFLE INSTALLATION AND BRICK NOTES
Follow these instructions to remove the baffle:
1.
Lift the front bricks over the front of baffle support and out
2.
Raise the front baffle support up to right and move the left end down and out the
door.
3.
Remove the rear secondary air tube, see section 4.6.
4.
Pull the rear baffle support forward off the rear bricks, lift the right end up and to
the right, move the left end down and out the door. Remove the rear baffle
bricks.
5.
When replacing the baffle, reverse these directions. Ensure that the rear bricks
are located on the back duct and on the side baffle supports. All baffle bricks
must be centred with the middle gap closed for proper operation.
Have any damaged firebricks replaced. Check the firebrick for damage annually and
replace the broken or damaged ones. A baffle layout diagram is shown in Figure 3.2.
Figure 3.2