Orion System OE392-10 System Manager TS - Manual (Page 77)

SMTS Technical Guide
Index B
77
T-V
Temperature Setpoints..........40, 52
Temperature Setpoint Screens..........40
This Unit is Installed on a Multiple Loop VAV..........52
This Unit Needs the Main Fan Status..........52
Time
Military Time Conversion..........61
Time and Date
Setting..........16
Time of Day..........14
Trendlog Interval..........46
Troubleshooting
LEDs and Buttons..........55
U
Unit Heat
Reheat..........37
Unit Selection..........19
Unit Selection Screen..........19
Unoccupied Cooling Offset..........40, 52
Unoccupied Heating Offset..........40, 52
Unoccupied Night Setback..........38
Up Arrow Key
Function..........12
Update LED..........55
USB-Link..........4
User-Confi gurable Relay Outputs..........49
User Passcodes Icon..........15
Description..........12
V
VAV Boxes
Broadcast..........40
VAV Box Setpoint Icons
Described..........13
VAV Capabilities..........36
VAV EPROM Requirements..........4
VAV/Zone Actuator Package Wiring..........11
VAV/Zone Alarms
Confi guring..........50
Disabling..........50
Enabling..........50
VAV/Zone Alarm Status..........50
VAV/Zone Controller Alarm Status Screen..........50
VAV/Zone Controller Temperature Setpoint Screen..........51
VAV/Zone Setpoint Buttons..........51
VAV/Zone Setpoints
Accessing..........51
Confi guring..........51
VAV/Zone Status Screens..........50
Viewing..........50
VCB-X Alarms
Confi guring..........22
Enabling/Disabling..........22
VCB-X Alarm Status
Viewing..........22
VCB-X Controller Alarm Status Screen..........22
VCB-X Controller Code..........1
VCB-X Controller EPROM Requirements..........4
VCB-X Controller Schedules Screen..........23
VCB-X Controller Status Screen 1..........20, 22
VCB-X Controller Wiring..........10
VCB-X Setpoint Buttons..........35
VCB-X Setpoints
Accessing..........35
Entering..........35
Setting..........35
VCB-X Setpoints
Building Pressure Control Rate..........45
Building Pressure Setpoint..........43
Building Pressure Signal High Volts..........47
Building Setpoint Deadband..........43
Calibration Offset..........48
CO
2
Maximum Setpoint..........43
CO
2
Minimum Setpoint..........43
CO
2
Sensor Calibration Offset..........47
Coil Setpoint High Reset Limit..........41
Coil Setpoint Low Reset Limit..........41
Coil Temperature Calibration Offset..........48
Controlling Week Schedule..........46
Control Mode High Alarm Offset..........40
Control Mode Low Alarm Offset..........40
Cooling High Reset Source..........41
Cooling Low Reset Source..........41
Cooling Low Temperature Cutoff..........41
Cooling Minimum Fan VFD Signal..........41
Cooling Min Off Time..........45
Cooling Min Run Time..........44
Cooling Mode Enable..........40
Cooling Outdoor Air Lockout..........41
Cooling Safety Cutoff Temperature..........41
Cooling Stage Down..........44
Cooling Stage Up..........44
Cooling Staging Window..........41
Daylight Savings Start Date..........47
Daylight Savings Stop Date..........47
Economizer Control Loop Time..........45
Economizer Enable Setpoint..........40
Economizer Maximum Position..........43
Economizer Minimum Position..........43
Economizer Signal Closed Volts..........47
Economizer Signal Open Volts..........47
Exhaust CFM Area..........44
Fan Purge Mode Delay..........45
Fan Speed Control Rate..........45