Orion System OE392-10 System Manager TS - Manual (Page 60)

Zone
Zone
VCM-X Co VCM-X Co
Appendix
SMTS Technical Guide 60
Alarm Polling Setup Using Prism II
Setting Up Alarm Polling for Controllers
In order to set up Alarm Polling to work with the System Manager TS,
you must have a CommLink and MiniLink Polling Device installed on
your system. The following procedure must be done for the MiniLink
Polling Device on each loop.
In the Loop Selection Window of the Prism II
Main Screen, select the loop where your Mini-
Link Polling Device is located. Then, in the
Unit Selection Window scroll down to Address
60 - MiniLink PD and click once on your selec-
tion. (Figure 51)
Figure 51: Loop & Unit Selection Windows
Figure 53: Polling Device Setpoints Window
Click the option at the top far right of the Polling
Device Setpoints Window. The Alarm / Override Polling Window will
appear. (Figure 54)
In the Alarm / Override Polling Window, click the box to the left of
each controller to choose alarm polling and push-button overrides for
that controller. A check mark in the box designates alarm polling/push-
button override.
The Polling Device Window will appear. (Figure 52)
Figure 54: Alarm / Override Polling Window
Click at the top of the screen. The Polling Device Set-
points Window will appear. (Figure 53)
Figure 52: Polling Device Window
Revised 8/29/11