Orion System OE392-10 System Manager TS - Manual (Page 51)

SMTS Technical Guide
VAV/Zone Controllers
51
Accessing and Entering VAV/Zone Setpoints
Accessing and Entering VAV/Zone
Setpoints
While in the VAV/Box Status Screen (see Figure 42), touch the
< Set-
points>
button found on the bottom menu bar.
NOTE:
Level 1 and Level 2 users can change occupied space
temperature setpoints, but only Level 3 users can change
all setpoints.
The Setpoint Screen that fi rst appears will always be the Temperature
Setpoints Screen. Figure 43 depicts a VAV/Zone Controller Temperature
Setpoint Screen.
Figure 26 depicts a VAV/Zone Controller Temperature Setpoint
Screen.
Figure 27 depicts a VCM-X Controller Temperature Setpoint Screen.
Use the up and down arrow keys to the right of the screen to move
through the setpoints. Touch the
button to return to the con-
troller’s status screen. Touch the various buttons on the bottom of the
screen to access other setpoint screens. Touch the
icon to go
back to the Main Screen.
Figure 43: VAV/Zone Controller Temperature
Setpoint Screen
Figure 42: VAV/Zone Controller Status Screen
Individual setpoint and confi guration buttons are located at the bottom
of the Setpoint Screens. See Figure 44. Simply touch a specifi c button
to access that category.
Within each Setpoint Screen, touch the < Status> button to return to the
Status Screen, or touch
< Home>
to return to the Main Screen.
Use the
<+>
and
<->
buttons to scroll through the setpoints and confi gu-
rations. Simply touch the blue highlighted box to change the setpoint.
Each setpoint data entry screen will provide a defi nition of the setpoint
and specifi c instructions for entering the setpoint and will include the
setpoint range as in the example below, Figure 45.
Touch to have the system accept the new value. If you enter a
setpoint that is not in the valid range, the setpoint will remain as is and
will not change.
Each setpoint data entry screen is self-explanatory; however, each
setpoint and confi guration is explained in the next section, Confi guring
VAV/Box Setpoints. To easily reference a particular setpoint or confi gu-
ration, refer to Index A.
Figure 45: Occupied Cooling Setpoint Data Entry
Screen
Figure 44: VAV/Zone Setpoint Buttons
Temps Misc Config Damper Alarms Calibrate