Desa FPVF33NRA - Manual (Page 9)

www.desatech.com 113109-01D 9
Figure 5 - Installing Hood to Firebox
CHECK GAS TYPE
Use the correct gas type (natural or propane/
LP) for your fireplace. If your gas supply is not
correct, do not install fireplace. Call dealer
where you bought fireplace for proper type
fireplace.
WARNING: This appliance is
equipped for either natural gas
or propane/LP gas but not both.
Gas type is indicated on the rat-
ing plate. Field conversion is not
permitted.
ELECTRICAL HOOKUP
(Models GA3700 Series and GA3700T
Series Blower Accessories and GA3555
Internal Duplex Kit)
This fireplace accepts a blower assembly with
an electrical cord. The electrical cord is five feet
in length. You must locate fireplace within reach
of a 120 volt grounded electrical outlet. If not,
you must install an electrical outlet within reach
of fireplace power cord. The GA3555 outlet
accessory is used for built-in applications with
blower accessory installed.
INSTALLING HOOD
Install hood to top of firebox as shown in Figure
5. Use 3 Phillips screws provided.
INSTALLATION
Continued
Figure 7 - Attaching Perimeter Trim to
Fireplace
Figure 6 - Assembling Perimeter Trim
Side Trim
Top
Trim
Slot
Mitered
Edge
Slot
Shim
Set Screws
Adjusting
Plate
Trim
Hanging
Screws
Assembled
Trim
Hanging
Notches
on Trim
1. Remove packaging from three pieces of
perimeter trim.
2. Locate four perimeter screws, two adjust-
ing plates with set screws and two shims
in the hardware packet.
3. Align shim under adjusting plate as shown
in Figure 6.
4. Slide one end of adjusting plate/shim in
slot on mitered edge of top perimeter trim
(see Figure 6).
5. Slide other end of adjusting plate/shim in
slot on mitered edge of side perimeter trim
(see Figure 6).
6. While firmly holding edges of perimeter
trim together, tighten both set screws on
the adjusting plate with slotted screw-
driver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.5
shoulder) into holes in cabinets. Place
the assembled trim onto fireplace cabinet.
Align hanging notches on trim with hang-
ing screws on side of fireplace (see Figure
7). Push trim firmly into place, sliding
hanging notches over hanging screws.
ASSEMBLING AND ATTACHING
OpTIONAL pERIMETER TRIM
(Included with Mantel Accessory)
IMPORTANT: If you are recessing the fire-
box in a wall, do not attach perimeter trim at
this time. See Built-In Fireplace Installation,
page 11.
Note: The instructions below show assembling
and attaching perimeter trim to fireplace.