Desa FPVF33NRA - Manual (Page 11)

www.desatech.com 113109-01D 11
INSTALLATION
Continued
8. Place cardboard or other protective mate-
rial on top of hearth base. Carefully set
fireplace on protective material, with back
of fireplace inside mantel opening.
9. Attach flexible gas line from fireplace gas
regulator to gas supply. See Connecting
Fireplace to Gas Supply, page 15.
10. If blower is installed, route blower electri-
cal cord through access holes in either
side of fireplace. Note: Bushing may be
moved if necessary. Plug electrical cord
into electrical outlet.
11. Carefully insert fireplace into cabinet
mantel. Be careful not to scratch or
damage hearth base, cabinet mantel or
any laminate trim on hearth base (VYGF
models only). Remove protective material
from top of hearth base and from front of
fireplace (if any). Note: You can secure
fireplace to hearth or floor. Open lower
louver. Locate screw holes in bottom of
base. Tighten wood screws through these
holes and into hearth or floor.
1. Check all gas connections for leaks. See
Checking Gas Connections, page 16.
Figure 10 - Installing Cabinet Mantel
Cabinet
Mantel
Figure 11 - Location of Nailing Flanges
Nailing
Flanges
Figure 12 - Inserting Fireplace Into
Cabinet Mantel
Actual Framing
Height 3 3 /
8
" 33"
Front Width 34 5 /
16
" 35 1 / "
Depth 16 11 /
16
" 17 3 /
4
"
BUILT-IN FIREpLACE INSTALLATION
Built-in installation of this fireplace involves
installing fireplace into a framed-in enclo-
sure. This makes the front of fireplace flush
with wall. If installing a mantel above the
fireplace, you must follow the clearances
shown in Figure 20, page 13. Follow the
instructions below to install the fireplace in
this manner.
Models VYGF33PRB and VYGF33NRB
1. Frame in rough opening. Use dimensions
shown in Figure 13, page 12, for the rough
opening. If installing in a corner, use dimen-
sions shown in Figure 14, page 12, for the
rough opening. The height is 33" which is
the same as the wall opening above.