OpenEye GraniteRack 1U - Manual (Page 20)

12 28079AB
5. Select “PCI Master – DMA Burst Mode” and set to Disable by pressing spacebar
6. Select “Support LUN# 0 Up to Max LUN#” and set to 3 by pressing the spacebar
7. Select “Include In Scan” and set to No by pressing spacebar
8. Select “SCSI Speed Setup” and press Enter
9. Configure the “XFER” speed to match the transfer rate that was set on the MODE dipswitch on the back of the 1U unit
10. Press Enter to exit SCSI Speed Setup
11. Press Enter to exit the Adapter Parameters Menu
12. Select Exit Setup and press Enter