OpenEye EasyNVR - Manual (Page 55)

32896AC 55
The Configuration menu allows you to export and import your recorder settings, and reset the recorder
back to factory defaults.
General Settings
Load Factory Default allows you to reset all settings and configuration to the default state. Click Load
Factory Defaul t, and then click Yes . Click Yes again to continue. The recorder will immediately pause
and begin loading defaults; there is no way to stop or undo this process. After approximately 60
seconds the recorder will restart.
Note This does not affect the recorded data on the internal hard drive (which can be done via the
Internal Disks menu).
The operations log can be toggled ON or OFF to designate if the operations log is viewable in the
Management tab.
Export Configuration
You can export the recorder settings to backup in case your settings need to be restored.
1. Connect a USB storage device to the recorder, and then click Export Configuration .
2. Click Destination .
3. Choose the USB drive you want to export your configuration to and select Yes .
4. Click File Name .
5. Use the on-screen keyboard to enter the desired file name (up to 15 characters).
6. Click OK .
7. Click Export , and then click Confirm.
8. Click Clos e or press any key to finish.
Import Configuration
You can import recorder settings from a backup of your configuration.
1. Connect a USB storage device to the recorder, and then click Import Configuration .
2. Click configuration file you want to import and then select Yes .
3. Click Yes again to Continue.
4. Click Close or press any key to confirm the configuration load and restart your recorder.
Note This load and restart may take up to 5 minutes and cannot be aborted or interrupted.