Onwa Marine Electronics KAP-866 - Manual (Page 19)

2.2.3 Select Magnetic Sensor Unit
There are 2 kinds of Magnetic Heading Sensor units are available from Onwa,
Fluxgate compass Top Sensor.
Note: Choice of Magnetic Sensor Unit
1) Fluxgate Sensor KFG25 and KFG28-FLUXGATE SENSOR
2) Compass Top Sensor KCS20-COMPASS TOP SENSOR
2.2.4 Trim Setting
Sometimes for some reasons the installation of Rudder Feedback Unit is not
100% aligned with the position of the Rudder. We could use the Trim Setting
to compensate the installation error.
Note: It is not advised to use this function to compensate the error if the angle
different is excess 5 degrees between actual rudder angle and display angle
from rudder feedback unit. Re-installation should be carried out if the said
angle error is excessed 5 degrees
SELECT REMOTE UNIT
SELECT RUDDER FEEDBACK UNIT
SELECT MAGNETIC SENSOR UNIT
TRIM SETTING
INSTALLATION MENU
AUTO HEADING ADJUST
MANUAL HEADING SETTING
HEADING ALIGNMENT SETTING
LANGUAGE SETTING
SELECT MAGNETIC SENSOR UNIT
Cancel [ES C] ok [EN T]
1. FLUXGATE SENSOR
2. COMPASS TOP SENSOR
SELECT REMOTE UNIT
SELECT RUDDER FEEDBACK UNIT
SELECT MAGNETIC SENSOR UNIT
TRIM SETTING
INSTALLATION MENU
AUTO HEADING ADJUST
MANUAL HEADING SETTING
HEADING ALIGNMENT SETTING
LANGUAGE SETTING
Cancel [ ESC] ok [E NT]
TRIM SETTING
+00
14