Onwa Marine Electronics KAP-866 - Manual (Page 15)

2. MENU SETTINGS 2. MENU SETTINGS
2.1 Function Menu
Press [MENU] to display the Function menu.
Turning the Knob to move cursor between the Function menu items. Press the
Knob to confirm the selection. Turn the Knob to change the setting in the
setting in the selected item. Press the Knob to confirm the setting or press
[ESC] to exit.
2.1.1 Set Rudder Limit
There are physical limitations to the angle that the rudder can move through.
If the autopilot attempts to drive the rudder past these limits, damage to
the steering gear may occur.
Setting Rudder Limit is to prevent the rudder from over-steer beyond the set
limit. The Rudder Limit will function before the steering system reach the
mechanic limit.
There are 2 symbols "P_L" (Port Limit) and "S_L" (Starboard limit) will
appear on the display. When you see either of these 2 symbols:
a) When rudder moves excess the set Port Limit (or Starboard Limit) a "P_L"
(or S_L) will appear on the display. No port (or Starboard) rudder movement
command will be sent out from the autopilot.
b) The functioning of Starboard Limit (S_L) us same as Port Limit (P_L)
Note: The factory default setting of Rudder limit is 30 degrees. That means if
rudder feedback unit is properly installed then when the rudder is moved over
Port or Starboard 30 degrees, the display will show P_L or S_L.
SET RUDDER LIMIT : 22
SET TRIM : +00
OFF COURSE ALARM : 00
STOPWATCH TIMER ALARM : 00
FUNCTION MENU
10