OnLine Power Constant Power 3 - Manual (Page 23)

OnLine Power
6002-034 REV. C 3-2
3-4-2 Unpacking Constant Power 3 and Mini-Power
The Constant Power 3 and Mini-Powers are shipped in a cardboard box with special foam barriers and supports
inside.
1. Open cardboard box with a knife using care not to damage the regulator inside.
2. Remove the foam barriers on top of the unit.
3. Remove the regulator from the cardboard box. Review Table 2-2 for the weight of the unit before lifting. The
Constant Power 3 can weigh as much as 80 pounds and the Mini-Power can weigh as much as 70 pounds.
4. Inspect the unit for damage per Section 3-4-3 Inspection.
5. Move the regulator to the installation site.
6. Before final positioning of the unit(s), verify all the routing of the input and output cabling.
3-4-3 Inspection
Perform the following Inspection procedure of the unit to check for obvious damage or safety hazards that may
have occurred during shipping or handling of the unit. All units must be inspected when received and again prior
to use. Any damage must be reported immediately to ON-LINE POWER, INC. or an authorized representative.
Freight damage claims should be initiated with the carrier.
CAUTION
Do not connect unit to building power until the following procedure has been completed.
1. Inspect all external surfaces (panels, covers, etc) for abrasions, indentations, or other obvious damage.
2. File a claim with shipping agency for any damage caused by shipping.
3. Forward a copy of damage claim to ON-LINE POWER, INC. at the following address:
ON-LINE POWER, INC.
Attn: Customer Service
5701 Smithway Street
City of Commerce, CA 90040