ONICON F-5100 Insertion - Manual (Page 3)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-5100 Insertion Thermal Mass Flow Meter Manual 05/15 - 0663-20 / 18333 Page 3
TABLE OF CONTENTS
1.0 INTRODUCTION ..................................................................................................5
1.1 PURPOSE OF THIS GUIDE .......................................................................5
1.2 TYPICAL INSERTION THERMAL MASS FLOW SENSOR .....................5
1.3 STANDARD FEATURES AND SPECIFICATIONS ....................................6
1.4 ADDITIONAL REQUIRED HARDWARE ...................................................7
1.5 ADDITIONAL HARDWARE THAT MAY BE REQUIRED .........................8
1.5.1 Flow Conditioners .......................................................................8
1.5.2 Additional Remote Mount Cable ................................................8
1.6 WORKING ENVIRONMENT .....................................................................9
1.7 WARRANTY & SERIAL NUMBER ............................................................9
2.0 UNPACKING ....................................................................................................10
2.1 CHECKING TO SEE THAT YOU RECEIVED EVERYTHING ..................10
3.0 INSTALLATION, REMOVAL AND ADJUSTMENT ..........................................11
3.1 INSTALLATION SITE SELECTION ........................................................11
3.2 MECHANICAL INSTALLATION .............................................................13
3.2.1 Installation Kits ..........................................................................13
3.2.2 Directions For Standard Installation (new construction) ........14
3.2.3 Directions For Hot Tap Installation (pressurized system) ........14
3.3 INSTALLING THE FLOW SENSOR ....................................................... 15
3.3.1 Determining the Insertion Depth, Inserting the Sensor and
Tightening the Compression Fitting .........................................15
3.4 REMOVING THE FLOW SENSOR ..........................................................18
3.5 ELECTRICAL INSTALLATION ...............................................................19
3.5.1 Analog Output ...........................................................................19
3.5.2 Pulse Output ..............................................................................19
3.5.3 Integral Mount Wiring ...............................................................20
3.5.4 Using the Pulse Isolator Module ...............................................21
3.5.5 Remote Mount Wiring ...............................................................22
4.0 START-UP & COMMISSIONING FOR ONICON INSERTION THERMAL MASS
FLOW SENSORS ................................................................................................23
4.1 DISPLAY ..................................................................................................23
4.2 POWERING THE SENSOR ......................................................................23
4.3 HELPFUL HINTS FOR START-UP & COMMISSIONING ......................23
4.4 START-UP & COMMISSIONING .............................................................24
4.5 START-UP & COMMISSIONING WORKSHEET .....................................25
5.0 TROUBLESHOOTING GUIDE ............................................................................26