Olson Technology MUSCLE-EM55X - Manual (Page 64)

OTOT-EM55X/XL Optical Transmitter Rev. x1 www.olsontech.com
63
Figure 51 — Setting the Event Mask for the Webserver and SNMP Interface of OTOT-EM55X
With this feature all warnings / alarms of the OTOT-EM55X can be either enabled or disabled by the user in relation to
the LED’s on the front panel, the Webserver status screen and SNMP interface. If the alarm/warning mask is applied a
notify message will be shown on the status menu screen.
Note: If the NEC software of a transmitter is upgraded to Rev. 1.9 or later, the OTOT-EM55X firmware might not sup-
port the alarm/warning flag mask, which means, that the LED’s on the front panel might not reflect the alarm/warning
masks.
Alarm Flags
Index Flag Description
0 TEC_HIGH_ALARM Peltier current is higher than the alarm limit (Laser switched off)
1 OUTPUT_PWR_LOW_ALARM Optical output power is lower than the alarm limit
2 RF_INPUT_LOW_ALARM RF signal is lower than the alarm limit
3 OUTPUT_PWR_HIGH_ALARM Optical output power is higher than the alarm limit
4 RF_INPUT_HIGH_ALARM RF signal is higher than the alarm limit
5 OMI_OR_RFGAIN_LOW_ALARM The calculated RF gain (if AGC on) or the calculated OMI (if AGC
off) is lower than the alarm limit
6 OMI_OR_RFGAIN_HIGH_ALARM The calculated RF gain (AGC on) or the calculated OMI (AGC off) is
higher than the alarm limit
...
28 MODULE_TEMP_LOW_ALARM Module temperature is lower than the alarm limit
29 MODULE_TEMP_HIGH_ALARM Module temperature is higher than the alarm limit
30 RESERVED Reserved for the NMS Controller (Do not use these bits)