Nortec ME Control Installation - Manual (Page 8)

8 Important notes on installation
3 Important notes on installation
3.1 Delivery
After receiving:
– Inspect shipping boxes for damage.
Any damages to the shipping boxes must be reported to the shipping company.
– Check packing slip to ensure all parts has been delivered.
All material shortages are to be reported to your Nortec representative within 48 hours after receipt
of the goods. Nortec assumes no responsibility for any material shortages beyond this period.
– Unpack the parts/components and check for any damage.
If parts/components are damaged, notify the shipping company immediately.
– Check whether the components are suitable for installation on your site according to the product
specification (refer to model key in the operation manual).
3.2 Storing/Transportation/Packaging
Storing
Until installation store the system components in its original packaging in a protected area meeting the
following requirements:
– Room temperature: 1 ... 40 °C
– Room humidity: 10 ... 75 %rh
Transportation
For optimum protection always transport the unit in the original packaging and use an appropriate lifting/
transporting device.
The packaged Nortec ME unit may be carried by fork lift from the underside, but caution should be exer-
cised to ensure that the load is balanced before lifting. Refer to the rating plate for weights and measures.
WARNING!
It is the customer's responsibility to ensure that operators are trained in handling heavy goods and to
enforce the relevant lifting regulations.
Packaging
Keep the original packaging of the components for later use.
In case you wish to dispose of the packaging, observe the local regulations on waste disposal. Please
recycle packaging where possible.