Nortec Blower Packs - Manual (Page 10)

7 | Blower Pack Installation Guide
Location and Mounting:
NH-EL Space
Refer to NH-EL Installation and operation manual (2570435) for instructions on mounting the NH-
EL.
RM-BP
To wall mount the RM-BP, use 2 #12 x 3” long wood screws, supplied by others. These screws must
be fastened securely on a 2 x 4 wood stud or equivalent support. If any spacer material is used
between the bracket and the structural material such as drywall, increase the fastener length
accordingly. DO NOT locate the humidifier any further then absolutely necessary from the blower
pack location as net output will be reduced as a result of heat loss through the steam line.

Blower packs have hot surfaces that could result in burns if touched.

Mount blower pack on a suitable wall or vertical surface.

Clearance dimensions shown are for reference only and are the minimum required for
maintenance of the humidifier. Consult local and national codes before final location and
installation. NORTEC does not accept responsibility for installation code violations.

Install only in areas with ambient temperature 41-104 °F (5 – 40 °C) relative humidity 5 - 95%
(non condensing).

When possible, mount the blower pack at a height convenient for servicing.
Figure 6. NH-EL Space Mounting Clearances