Nortec MH Series User Manual
Page 47
MH Series | 43
Dismantle and Install the UV Lamp (option)
1. Pull the retaining clip out to release the uv light plug.
2. Carefully lift the plug and pull the uv lamp out of the housing.
3. Remove glass tube through the top.
4. Clean glass tube outside and inside
with a lint-free and soft cloth.
The installation of the uv lamp follows the reverse dismantling order.
Caution! When installing the uv lamp, make sure to hold the lamp until it is completely
inserted. Under no circumstances let the lamp fall inside the holder, since this could damage
the lamp.
Resetting the Maintenance Indication
When maintenance work has been completed the maintenance indication must be reset on
the MHTC flow, and MHTC reflow (yellow led lights). For that purpose, please observe the
information given in the separate operating instructions for the MH control unit.