Electrical – Nortec MH Series User Manual
Page 37
MH Series | 33
Electrical
Note: Electric installation of the NORTEC MH “Flow” and “Reflow” models is the clients responsibility.
Figure 25: Leading the electrical cables out of the duct
Lead the low voltage multi conductor control cable via liquid tight conduit fittings, “A” out of
the duct.
MH Reflow models – Install a power cable rated for plenum use and meeting all local electrical
codes (not provided) to the wires in the pump motor’s junction box “B”. Route the power cable
out of the duct via liquid tight conduit fitting.