NavCom RT-3020 Rev.D User Manual
Page 20

RT-3020 User Guide - Rev. E
To power the unit on or off, the I/O switch must be
depressed for more than 3 seconds. During power up of
the
GPS
sensor, all
LED
s will be on for a period of 3-5
seconds.
Link LEDs
The Link lights are software configurable via the
appropriate NavCom
proprietary command
. Because of
the numerous scenarios available for the Link light, only
the factory default configuration [
Rover
Mode] is
discussed.
LINK Status
Command
Mode
Rapidly repeating Red to Amber to Green
indicates Searching for base radio signal.
Strong Signal Strength from the base radio.
Medium Signal Strength from base radio.
Weak Signal Strength from base radio.
Table 3: Link Light Indication
Base LEDs
If the RT-3020 has been configured as a
Base Station
,
the
LED
s indicate the type of
RTK
corrections being
produced. Where the color of the
LED
will indicate the
format of the correction, the blink rate indicates
specifically which message is being sent. Table 4
2-18