MultiDyne CTV-2000-FRX - Manual (Page 8)

CTV-2000 Series Broadcast Transmitter Users’ Manual (REV 1.0)
8
⑥ “RF INPUT = XXdBmV”: RF input level
⑦ “ATT= XXdB”: attenuation value
⑧ “MODEL LEVEL= XXdBmV”: modulating level value
⑨ “S/N: xxxx-xx-xxxx”: equipment series number
5.4 Alarm Indication
Display Message Alarm Status System Indication
Warning…!!! Input RF is low Input RF is too low
• Status indicator red
light flashes
Warning… !!! Input RF is high Input RF is too high
• Status indicator red
light flashes
Chapter 6 Installation & Adjustment
6.1 Opening the cover
6.1.1 Inspect the package. If there is any damage or watermark, please contact the freight company or
contact our company.
6.1.2 After unpacking, check equipments and accessories according to packing list. Any question, please
contact local dealer or our company.
6.1.3 If you think equipment has been damaged, please don’t turn on the power and avoid worse damage.
Please contact local dealer or our company.
6.2 Apparatuses & Tools
An optical power meter
A digital multimeter
A frequency analyzer
A standard fiber test jumper (FC/APC or SC/APC)
Waterless alcohol and nosocomial degrease cotton
6.3 Installation
a. Fix equipment on rack and ground the case.
b. Check voltage by digital multimeter in accordance with power requirement and make sure laser lock
is OFF. Then turn on power.