MovinCool Climate Pro 18 - Manual (Page 26)

26
OPERATION (cont.)
Heat Mode Operation
1. If the unit is in standby mode, simply press
MODE button until “HEAT” appears, then press
START/STOP button. LCD displays a
confirmation screen. Press START/STOP button
once again to start HEAT mode operation. LED
color changes from orange to green.
Note: If no button is pressed for 1 minute, LCD
automatically displays the previous mode.
2. If the unit is in already in operation, press
MODE button once. The operation status
screen displays the current operation mode.
Press TEMP+ or -TEMP button to go to HEAT,
then press ENTER button to select.
3. LCD displays a confirmation screen as shown
on the right.
4. Use TEMP+ or -TEMP button to change set
point temperature. LCD displays “MIN” or
“MAX” when set point value is at minimum or
maximum.
5. Use FAN+ or -FAN button to change fan speed
(HI, MID, LO).
Note: When the ambient temperature is high,
fan speed is automatically changed from LO to
MID during HEAT mode operation.
6. To stop HEAT mode operation, press START/
STOP button. LCD displays a confirmation
screen. Press START/STOP button again. LED
color changes from green to orange.
ILL00790-00
ILL00791-00
ILL00792-00
ILL00793-00
ILL00794-00