MovinCool Classic 40 - Manual (Page 28)

28
INSTALLATION (cont.)
Warning Signal Connection
(Output Signal Terminal L+ and L-) (cont.)
Connecting Warning Signal from Controller
3. Insert the warning signal wire through the clip, grommet, and hole in the right
side panel.
Note: Use recommended warning signal wire size from 16 AWG to 26 AWG
for a solid wire, or 16 AWG to 22 AWG for a stranded wire with ring terminal
for #6 stud size.
4. Connect the warning device to terminal L+ and L- according to its polarities.
UNIT TERMINAL
INPUT SIGNAL RELAY OUTPUT CONTACTOR
WARNING DEVICE
E+
E-
L+
L-