MovinCool Classic 40 - Manual (Page 21)

21
INSTALLATION (cont.)
Optional Accessories and Set Up Configuration (cont.)
Unit Suspended from the Ceiling (For Classic 40 ONLY)
3. Duct Work Procedure
Reverse the blower casing inside the unit.
1. Remove the right side panel.
2. Remove the water guard located at the lower blowoff port.
3. Remove the blind plate located at the lower blowoff port and install it to the
upper blowoff port, and remove the grill located at the upper blowoff port
and install it to the lower blowoff port.
4. Remove five nuts and reverse the blower casing 180°. Then set the
opening of blower casing to the lower blowoff port and tighten the blower
casing with the nuts.
5. Install the right side panel.
BLIND PLATE
BLOWER CASING
BLIND PLATE
WATER GUARD
LOWER BLOWOFF PORT
UPPER BLOWOFF PORT
RIGHT SIDE PANEL
NUTS
REVERSE BLOWER
CASING 180°
POSITIVELY SET THE OPENING
OF BLOWER CASING
TO LOWER BLOWOFF PORT