MovinCool Classic 40 - Manual (Page 18)

18
INSTALLATION (cont.)
Optional Accessories and Set Up Configuration (cont.)
Unit Suspended from the Ceiling (For Classic 40 ONLY)
When the unit is suspended from the ceiling, cooling air can be sent from the
bottom of the unit. More information is available at WWW.MOVINCOOL.COM.
WARNING: Make sure that the ceiling structure is capable of
supporting the weigh of the unit, suspension hardware, and the
accessories.
Note:
1. Use standard suspension metal fittings.
2. Do not suspend the unit from the ceiling of a lightweight steel-frame building or
wooden building.
3. Make sure to lock the shackle pin with copper wire.
4. Make sure to securely tighten the nut-tightening portion with double-nut locking.
5. If you are uncertain about the strength of ceiling structure, from which the unit
is suspended, consult the architect.
6. When working in high places during the installation of unit, provide positive
safeguards, such as using a lifeline.
7. After the unit is suspended from the ceiling, make sure that the unit is level. If
the unit is not level, adjust each suspension length of the unit with an eyebolt.
If the unit slans more than 1.5° horizontally, the drain water will overflow.
8. When the unit is configured as suspended from the ceiling, the signal output can
be used with alarm speaker or light indicator to monitor proper operation.
U-BOLT
EYE BOLT
EYE NUT
SECURELY TIGHTEN WITH
DOUBLE NUT LOCKING
LOCK BY BINDING WITH
1/16 in. DIA. COPPER WIRE
SHACKLE
BRACKET
SPAN OF BUILDING
DUCT
SHACKLE
SHACKLE
SHACKLE PIN
ROD
ROD