MicroE 3500V Mercury - Manual (Page 9)

Installation Instructions
Rotary Encoders
Page 7
6
Confirm proper alignment
over the full range of motion.
The “Proper Alignment” LED
must remain on over the
entire range. If not aligned
over the entire range of
motion, loosen the sensor
mounting screws and repeat
step 5.
5
If benching dimensions cannot be provided, proper sensor alignment may require minor adjustments
to the sensor position with respect to the scale. This can be performed easily using the LED alignment
indicators, as illustrated below.
The red, yellow, or green LED will light depending on sensor alignment. Slowly move the sensor by
allowing it to slide on the mounting surface until the green or Proper Alignment LED, is illuminated.
Optimal alignment will be displayed as a “Bright Green” LED.
IIM MP PO OR RT TA AN NT T: Confirm that the Proper Alignment LED blinks when passing over the index. If not,
readjust the sensor in the Y direction and repeat the above procedure. When alignment is completed,
tighten the sensor mounting screws.
x
Y
Z
θ
z
To align the sensor, move it
in the Y or
θ
z directions.
IIM MP PO OR RT TA AN NT T
O OU UT TP PU UT T C CA ALLIIB BR RA AT TIIO ON N P PR RO OC CE ED DU UR RE E
This procedure must be completed for
proper system operation each time the
sensor is aligned or if the SmartPrecision
electronics module is replaced.
Position the sensor at least 7mm (1/4”) away
from the index mark on the scale. Next, push
the Index/Calibration
button inside the
module with a small
diameter shaft, such
as a bare cotton swab.
The Power/
Calibration indicator
will flash continuously. Move the scale past the
sensor in both directions so that the index mark
passes under the sensor. Do not run off the end
of the scale when using a segment scale. When
the calibration procedure is complete, the
Power/Calibration indicator stops flashing.
7
Power/
Calibration
indicator
Index /
Calibration
button
Proper
Alignment
indicator
Improper
Alignment LED
Red
Power/
Calibration
Power/
Calibration Power/
Calibration
Improved
Alignment LED
Yellow
Proper
Alignment LED
Green
Optimal
Alignment LED
Bright Green