Metz MECABLITZ 50 AF-1 digital Canon - Manual (Page 96)

96
ķ
Setting procedure
• Press the button combination „Select“ until
„FB“ flashes in the display.
• Apply the setting desired with the buttons
+ and —. The possible correction values
range from 1/3 to 3 apertures in one-
third aperture increments. The correction
value will always be shown positively.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and the setting is saved auto-
matically.
For the first shot of a flash bracketing series „FB“ and „A“re shown in the
display. For the second shot „FB“, „B“ and the minus correction values are
displayed. For the third shot „FB“, „C“ and the plus correction values are
displayed. After the third shot, „FB“ is deleted from the display and the flash
bracketing series is deactivated.
It must be reset for another flash bracketing series! ☞
9.4 Auto OFF for the flash unit
The auto OFF for the flash unit can be set so that it occurs after 10 minutes,
1 minute or is deactivated.
Setting procedure
• Press button combination „Select“ until
the symbol flashes.
• Apply the setting desired with the
buttons + and —.
– When „10min“ is displayed, Auto OFF
function will be activated after `
10 minutes.
– When „1min“ is displayed, the Auto OFF will be
activated after 1 minute.
– When „OFF“ is displayed, the Auto OFF is deactivated.
The setting takes effect immediately.
After about five seconds the display stops flashing and the setting is saved auto-
matically.
After activation of the auto OFF the display shows .
FB
FB
☛☛
FB 1,3
FB 1,3
☛
OFF
10min Ȅ
Ȅ
☛☛
OFF
10min Ȅ
☛
10min
709 47 0175.A2 50 AF-1 C 26.08.2010 15:53 Uhr Seite 96