Metz MECABLITZ 50 AF-1 digital Canon - Manual (Page 95)

95
ķ
9.2.2 SERVO mode
Servo mode is a simple slave mode with complete preflash suppression, in
which the slave flash unit always triggers a flash as soon as the camera flash
unit receives a light pulse.
Adjustment procedure for SERVO flash mode
• Set the camera to E-TTL mode.
• Press the "Select" button repeatedly until
blinks on the display.
• Press the + button to activate remote slave
mode.
• Press the + button again and activate ser-
vo mode. In servo mode, only manual
flash mode is possible. Manual flash mode
is automatically activated after swit-
ching to servo mode.
• Partial lighting levels can be set with the + and - buttons.
• Wait for the flash-readiness of all connected flash units. Once the slave flash
unit is ready, its AF measuring beam ቭ will start blinking.
Slave groups and remote channels can not be set in SERVO mode.
The flash unit may not be activated in remote mode. ☞
☞
M
SL
Turn off SERVO flash mode
• Press the button sequence repeatedly until
SERVO blinks on the display.
• Press the – button twice to turn the SERVO
mode off.
9.3 Flash bracketing series („FB“)
A series of flash exposures FB (flash bracketing) can be carried out in the TTL
flash modes (
, E , E HSS; see 7.1). A flash bracketing series consists
of three successive flash shots with different flash exposure correction values:
• The first shot is carried out without correction value.
• The second shot is made with a minus correction.
• The third shot is made with a plus correction .
• After the third shot, the flash bracketing series is automatically deleted.
A flash bracketing series can only occur if the camera supports the set-
ting of a manual flash exposure correction on the flash unit (see ch. 8
and the camera’s operating instructions)! Otherwise the shots will be
made without correction values! ☞
TTL TTL TTL
On
SL SL
☛☛
SERVO P 1/1
Zoom 24 mm
M
☛
SERVO
OFF
SL
☛
OFF
709 47 0175.A2 50 AF-1 C 26.08.2010 15:53 Uhr Seite 95