Metz MECABLITZ 64 AF-1 digital Olympus - Manual (Page 163)

163
Set number of flashes (N)
• Press the sensor button for the number of
flashes on the touch display.
• Press the sensor buttons on the
touch display and select the desired num-
ber of flashes.
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example
.
The setting will take effect immediately.
N
4
Setting the flash frequency (f(Hz))
• Press the sensor button on the touch
display for the flash frequency .
• Press the sensor buttons on the
touch display and select the desired fre-
quency of flashes.
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired frequency of flashes
in the example
.
The setting will take effect immediately.
The valid distance to the set parameters is
shown on the display.
The distance value displayed can be adjusted
to the distance from the subject by changing
the f-stop or the partial light output.
The aperture and ISO values are not shown
on the display in Strobe flash mode!
The secondary reflector is not supported in
stroboscopic flash mode.
f (Hz)
8
f (Hz)
O
q p
7
8
9
3.1m
M-
Zoom 35 m
m
STROBO
i
P
1/16
f(Hz) 10 N 4
3.1m
M-
Zoom 35 m
m
STROBO
i
P
1/8
f(Hz) 8 N 4
k
+
+
+
3.1m
M-
Zoom 35 m
m
STROBO
i
P
1/16
f(Hz) 10 N 5
N
O
q p
3
4
5