Metz MECABLITZ 64 AF-1 digital Canon - Manual (Page 192)

192
k
Setting procedure
• Press the ቨ button as often as it takes
for the selection menu to appear.
• Press the sensor button on the
touch display.
• Press the sensor button on the
touch display and select "REAR".
• Press the sensor button on the touch
display.
• Press the sensor button on the touch
display.
The setting is adopted immediately.
"REAR" appears in the INFO menu after acti-
vation of the REAR function.
If high-speed synchronisation (HSS, see 7.4)
is set on the flash unit and the synchronisati-
on is set to the 2nd curtain, then high-speed
synchronisation (HSS) is deactivated.
The set high-speed synchronisation (HSS) is
deleted by the activation of "REAR".
The "REAR" function set is deleted by the
activation of the high-speed synchronisation
(HSS).
ON
OPTION
D
REAR
11.2 RAPID mode
In flash modes A and ETTL, the recycling
times depend on how much light is needed
for the exposure. If the recycling time is too
long, the RAPID function can be switched on
in the A and ETTL flash modes. The RAPID
function is recommended especially in cases
where fast recycling times are more impor-
tant and maximum flash
output is less important, such as in relatively
small spaces. However, the guide number is
reduced by 1 level, e.g. from a guide number
of 36 (at ISO 100 zoom 35) to guide number
25 (at ISO 100 zoom 35).
Setting procedure
• Press the ቨ button as often as it takes
for the selection menu to appear.
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on the
touch display.
• Press the or sensor button on
the touch display and switch the RAPID
function on or off.
The setting is adopted immediately.
After activation of the RAPID function, „ ”
appears in the display.
D
OPTION
RAPID
RAPID
OFF ON
OPTION
O
q p
RAPID
SUB-REFL.
OPTION
RAPID
O
OFF
ON
OPTION
O
q p
REAR
RAPID
OPTION
REAR
O
OFF
ON