Measurement Computing Extender 488HS Rev.2.0 - Manual (Page 6)

Section 1 Introduction
1.2
1.2 Available Accessories
The following accessories are available from IOtech for use with the Extender488/HS
Bus Extender:
CA-7-1 1.5 foot IEEE 488 cable
CA-7-2 6 foot IEEE 488 cable
CA-7-3 6 foot IEEE 488 cable; shielded
CA-7-2 6 foot IEEE 488 cable; reverse entry
CA-56-30 30 m. Shielded parallel cable with mating connectors for the
Extender488/HS
CA-56-10 10 m. Shielded parallel cable with mating connectors for the
Extender488/HS
CN-20 Right angle IEEE 488 adapter
CN-48 Extender488/HS cable adapter
CN-22 IEEE 488 multi-tap bus strip; 4 connectors in parallel
CN-23 IEEE 488 panel mount feed-thru connector
MAN-116-0015 Additional Manual
Refer to the IOtech catalog for those accessories not listed here.
1.3 Specifications
IEEE 488-1978
Implementation:
Proprietary transparent control and data transfers.
PASS CONTROL is not supported.
Connector: Standard IEEE 488 connector with metric studs.
Parallel Interface
EIA RS-422A:
Balanced voltage on all signal lines.
Connector: 50-pin Centronics female.
Max. Cable Length: 1000 meters.