Measurement Computing Extender 488HS Rev.2.0 - Manual (Page 14)

Section 2 Getting Started
2.6
2.5 Hardware Installation
Included with the Extender488/HS Bus Extender are accessories for rack or bench use. If rack
mount installation is required, install the two rack ears using the enclosed screws. These ears can be
installed so either the front or the rear of the unit faces the front of the rack fixture.
Enclosure
Rack Ear
Top View
(2 per ear)
Enclosure
Top or Bottom View
Screw
View of Enclosure showing Rack Hardware Installation
If bench installation is required, the rubber feet can be installed on the underside of the unit near
each corner.
Enclosure
Top View
Enclosure
Bottom View
View of Enclosure Bottom Showing Feet Placement