Measurement Computing Extender 488HS Rev.2.0 - Manual (Page 10)

Section 2 Getting Started
2.2
(for the Extender488/HS Bus Extender connected to the Local bus) or Remote
Extender Mode (for the Extender488/HS Bus Extender connected to the Remote bus).
When both units are on, the Local bus extender will monitor all local bus
activity and transmit this activity to the Remote bus extender. All activity detected by
the Remote bus extender is also communicated back to the Local bus extender.
WARNING
Never open the Extender488/HS Bus Extender case while it is
connected to the AC line. Failure to observe this warning may
result in equipment failure, personal injury or death.
Switch
Side
View
DOT
0
1
1 2 3 4 5 6 7 8
Mode
0
1
1 2 3 4 5 6 7 8
Remote Extender
Mode
Local Extender
Not Used Not Used
Extender488/HS Configuration Selection
Note: Factory default setting is REMOTE .