Measurement Computing Isolator488 - Manual (Page 18)

Section 2 Getting Started
2.9
2.5 Hardware Installation
Included with the Isolator488 Bus Isolator are accessories for rack or bench
use. If rack mount installation is required, install the two rack ears using the
enclosed screws. These ears can be installed so either the front or the rear of the
unit faces the front of the rack fixture.
View of Enclosure showing Rack Hardware Installation
Enclosure
Rack Ear
Top View
(2 per ear)
Enclosure
Top or Bottom View
Screw
If bench installation is required, the rubber feet can be installed on the
underside of the unit near each corner.
View of Enclosure Bottom Showing Feet Placement
Enclosure
Top View
Enclosure
Bottom View